If your dash looks like this, then this mount will fit.
If you have smaller units that are not listed in the options, please go to: (2025+) Excell EX200 - Single Dash Mount - Plate# EL100
Disclaimer: The Apex Factory Gimbal brackets have a Hole Pattern in them that "Does Not" match any previous hole pattern used by Humminbird in the past. We will send a Hole pattern with mounts that have a Apex model graph and you will need to mark your factory Apex gimbal Bracket and drill 9/32 holes them to match our pattern.
Note: The BBT Cheyenne Series Apex Gimbal Brackets will have the same hole pattern in them as Helix and Solix Gimbal Brackets.
|
On your Excel Boat, if you have tilt wheel, you are good to go and nothing is needed. Excel Boats sometimes use a steering wheel that is a 1-piece steering wheel/hub and only uses 1 nut to hold it on the steering shaft. If your boat has Hydraulic Steering, then your steering wheel should measure about 7" from the dash to the inside top edge of the steering wheel. If that is the case, then no spacer should be needed in most cases. If the measurement is under 6 3/4"on that measurement, then you will need a complete changeover kit to be able to add a spacer to increase the space between steering wheel and sonar. Steering Wheel Changeover Kit can be purchased here. |
