These "Wedge" mounts are specifically designed for the Phoenix PHX series Bow. These mounts are designed to rotate the mount base to put the GPS/Sonar screens in line with the Trolling Motor Pedal and sitting the screens Level.
Dual Stack Bow Brackets kit includes a Heavy Duty Replacement Factory Plate
| Disclaimer: The 2020+ Phoenix Elite and newer PHX with fiberglass Shroud (10" x 16" Plate Type A, D, G, H), The Factory Bow Plate has NO set hole pattern for us to use to put holes in our main plate for mounting, so until Phoenix standardizes the mounting hole pattern, BBT will not put these holes in our plates. You will need to lay your factory plate or Dual Fiberglass shroud on top of our plate and mark your hole pattern in our plate and Drill holes to match your Bow pattern. Make sure that the holes are marked from the top side so it will match your hole pattern in your Boat. You will use the Factory screws to mount the main plate back in place. |
These "Wedge" mounts are specifically designed for the Phoenix PHX and 721 / 818 Pro XP series Bow. These mounts are designed to rotate the mount base to put the GPS/Sonar screens in line with the Trolling Motor Pedal and sitting the screens Level.
New: There is now an option in the dropbox to get either the "Standard Stack Top" or "Off-Set Right" Stack Top. The "Offset Right" tops are designed to shift both units to the right 2 inches allowing for better control of the Trolling Motor Cables, especially the Garmin Force TM and Lowrance Ghost TM large cables. These will fit any Dual Stack mount from BBT. See Example Pics. We will send the correct Top to fit what Boat Model you are buying for on the order.
THERE ARE 4 DIFFERENT PLATE SIZES
Dual Plate Sizes
-
Phoenix 721 PRO XP & PHX (2017-2018+)
Bow Type B -
Phoenix 721 PRO XP & PHX (2017-2018+) Bow Type D -
Some Phoenix 818 Pro Model (2021+)
Bow Type E -
Phoenix 721 PRO XP & PHX (2017-2018+) Bow Type F -
Phoenix 721 PRO XP & PHX (2017-2018+)
Bow Type G
